Table of Contents
Advertisement
8,
8
Attach the Backrest (62) and the Seat Back (98) to
the Backrest Frame (42) with two M6 x 20mm Button
Screws (20), an M6 x 45mm Button Screw (80), and
an M6 Washer (60),
Slide the Backrest Frame (42) onto the Seat Frame
(7), Attach the Backrest Frame with four M8 x 25mm
Button Screws (79) and four M8 Split Washers (55),
9.
identify the Left Pedal (22), which is marked with an
"L," Using an adjustabb
wrench, firmly tighten the
Left Pedal countemlockwise
into the Left Crank Arm
(24), Tighten the Right Pedal (not shown) clockwise
into the Right Crank Arm, Important:
Tighten both
Pedals as firmly as possible.
After using the
exercise
cycle for one week, retighten the
Pedals. For best performance,
the Pedals must
be kept tightened.
identify the Left Pedal Strap (25), which is marked
with an "L," Attach the Left Pedal Strap to the Left
Pedal (22), and adjust it to the desired position,
Attach and adjust the Right Pedal Strap (not shown)
in the same way,
10, The Console (4) requires four "D" batteries (not includ-
ed); alkaline batteries are recommended,
Slide the
battery cover off the Console, insert four batteries into
the battery compartment, Make sure that the batter-
ies are oriented
as shown by the diagram
inside
the battery compartment.
Slide the battery cover
back onto the Console, Note: When the batteries are
installed correctly, the fan will turn on for a moment,
10
/
62
98
/
/
42
/
55
25
Batteries
11, Make sure that aH parts are property tightened
before you use the exercise cycle. Note: After assembly
is completed, some extra parts may be left over, Place a mat beneath the exercise cycle to protect the floor,
8
Hide quick links:
Advertisement
Table of Contents
