Craftsman 247.886913 Operator's Manual page 10

.
Makesureall cables are routedto the left of the chutecontrol
rod.Line up the hole in the rod with thearrowon the inputshaft
and insertthe end of the rod into the inputshaftbelowjoystickon
handlepanel.See Figure7.
NOTE:Thechute controlrod will fit snugglyintothe inputshaft.
Supportthe rear of thedash panelwith one handwhileinsertingthe
rod with yourotherhandto ensurethe rod is insertedell the way into
the input shaft.
8. Nowpushthe chutecontrol rod back towardsthe handlepanel
untilthe hole in the rodlines up with the hole in the chute control
inputclosestto the chutecontrolhead. Insertthe cotterpin. See
Figure8.
NOTE:The secondholeis usedto achievefurther engagement o f the
rod intothe inputshaft if requiredand can be usedlaterfor adjustment
if the chutedoes notfully rotate.Referto the Service& Maintenance
sectionfor ChuteControlRodadjustments.
9. Finishsecuringchute controlheadto chutesupportbracketwith
wing nut, and clevispin and bow-tiecotterpin removed earlier.Do
notovertighten.See Figure9.
/i _
.J
Figure8
/
/
' ..................................................... i_"i
}
Figure7
Figure9
10