MTD Series 600 Operator's Manual page 10

I
NOTE: Forshipping
reasons, seatsare
_eitherfastenedto
thetractorseat's
pivotbracket witha
plastic tie, ormounted
backward to the pivot
shippingposition and
; removethetwo hex
i screws(orknobs_on
i _°d __:_otqodmP: f _ al
i beforeproceeding with
applicableinstructions.
Figure 3-4
Figure 3-5
Figure 3-6
Attaching The Seat
Seatstyles vary bytractormodeland thereare three
differentstyles available:
• StandardAdjustment
• QuickAdjustment&
• KnobAdjustment
If the seatfor yourtractordid notcome attached,referto
Fig. 3-4, Fig. 3-5,and Fig. 3-6 to identify yourtractor's
seat styleand followthe applicableinstructionsbelowto
attachit.
NOTE:Forshippingreasons,seatsare eitherfastened
to the tractorseat'spivot bracketwith a plastictie, or
mountedbackwardto the pivot bracket.Ineithercase,
freethe seat from its shippingpositionand removethe
two hex screws(or knobs,on modelsso equipped)from
the bottomd seatbeforeproceedingwith applicable
instructionsbelow.
Standard Adjustment Seat
1. Positionthe shoulderscrews(foundon the based the
seat) insidetheslot openingsin the seat pivot bracket.
See Fig. 3-4.
2. Slide the seatslightlyrearwardin the seat pivot
bracket,liningup the rearslots in the pivot bracket
with the remainingtwo holesin the seat'sbase.
3. Selectdesiredpositionforthe seat,and securewith
the two hex screwsremoved earlier.See Fig.3-4.
Quick Adjustment Seat
NOTE:If your seatwas shippedmountedbackwardson
the seat pivotbracket,pull outthe tab foundon the seat
stop and hold it open whileslidingthe seatoff the seat
pivot bracket.See Fig. 3-5.
1. Line up the plasticseat spacerswith the slotsin seat
pivot bracket.
2. Slide seat inuntilfront seat spacerengagesthe seat
stop.See Fig. 3-5.
WARNING:Before operating this machine,
make sure the seat is engaged in the seat
stop, stand behind the machine and pull
back on seat until fully engaged into stop.
Knob Adjustment Seat
1. Positionthe shoulderscrews(foundon the based the
seat) insidetheslot openingsin the seat pivot bracket.
Fig. 3-6.
2. Slide the seatslightlyrearwardin the seat pivot
bracket,liningup the rearslots in the pivot bracket
with the remainingtwo holesin the seat'sbase.
3. Selectdesiredpositionforthe seat,and securewith
the two knobs removed earlier.See Fig.3-6.
10