Maintenance - Fisher & Paykel Multifunction oven User Manual

Maintenance

Electrical Shock Hazard
Ensure the appliance is switched off before replacing the lamp/light bulb.
Failure to do so could result in electrical shock.
How to change the oven light bulbs
The oven is illuminated by three 12 volt/20 watt halogen bulbs. These have a very long life,
but if you should need to replace one, follow these steps:
Turn the oven off and allow it to cool.
1
Take out the shelves and use a small flat head screwdriver to twist and lift the retainer clip at
2
the top of the glass light cover while holding the glass to prevent it falling. The clip pivots
counter-clockwise (see the diagrams below).
Carefully lift the glass cover out of the lower support and pull out the faulty bulb.
3
Holding the replacement bulb in a soft cloth or tissue (touching the bulb will reduce its life
4
span), insert the new bulb. The two pins are vertically orientated.
Reposition the glass cover and twist the top clip back in place. The procedure is the same for
5
the light in the roof of the oven cavity.
WARNING!
Retainer clip
Sockets for
the pins
Plate glass cover
Pins
Replacement bulb
41