Table of Contents
Advertisement
•
Remove any buildup of grass and leaves on or
around the motor cover (do not use water). Wipe
the mower clean with a dry cloth occasionally.
•
If debris is allowed to build up on the underside of
the unit, tilt the mower forward or on its side and
scrape it clean with a suitable tool.
Lubrication
At the beginning and end of each mowing season:
•
Lubricate the springs on the rear discharge door
with a light oil.
•
Lubricate the height adjustment levers and related
hardware with light oil.
•
Remove the wheels and lubricate the surface of the
axle bolt and the inner surface of the wheel with
light oil.
•
Remove the blade and blade hub assembly and
lubricate the motor shaft with light oil or engine oil.
Refer to Figure 11.
SECTION 9: OFF-SEASON S TORAGE
The following steps should be taken to prepare the lawn
mower for storage.
•
Make certain the power supply is disconnected.
•
Clean mower as instructed in previous section.
•
Inspect and replace/sharpen blade if required.
Refer to the Maintenance section on page 12.
•
Lubricate the mower as noted above.
•
Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer and rock
salt.
•
Wipe extension cord to remove any foreign
substance such as oil or stains. Replace extension
cord if cut or damaged in any way.
•
Wind cord in a series of equal loops on each side of
your hand to prevent snarling.
Store mower indoors, in a cool, dry place, out of
reach of children. Do not cover lawn mower with a
solid plastic sheet. Any plastic covering traps
moisture around the mower which promote rust and
corrosion.
The
handle
may
be folded
away
completely
for
storage.
•
Loosen the hand knobs on the sides of the handle,
and fold the upper handle down.
Remove the hairpin clips, pull outward on each side
of the lower handle, and lift the sides of the lower
handle past the edges of the handle mounting
brackets. Fold the lower handle forward. Make sure
not to bend or kink the power cord.
13
Advertisement
Table of Contents
