Table of Contents
Advertisement
I
8
. Remove the belt from between the idler pt lley and
the belt guard on the idler pulley bracket, Tefer to
figure 32.
9. Remove the belt from the transmission pulley.
10. Assemble the new belt as follows.
A. Push the idler pulley up out of the way as
shown in figure 31.
B. Slide the belt in from the rear of the deck, and
place it around the transmission pulley. See
figure 31.
C. Release the idler pulley so it falls down into
position. Slide the belt in between the idler
pulley and the belt guard on the idle' pulley
bracket as shown in figure 32.
D. Grease the crankshaft. Place belt between the
two pulley halves, and reassemble th e blade
adapter and blade. Reassemble the inside belt
guard.
E. Reassemble the transmission belt cover, follow¬
ing instructions in step 4 in reverse o-der.
NOTE: When reassembling the transmission belt cover,
be certain the belt guard on the transmission < over is
approximately 1/8" away from the belt. Make certain
to tighten all nuts and bolts securely. If plas ic was
placed under the gas cap, be certain to remo ve it.
FIGURE 32.
OFF-SEASON STORAGE
The following steps should be taken to prepare lawn
mower for storage.
1
. Clean and lubricate mower thoroughly as de¬
scribed in the lubrication instructions.
2. Refer to engine manual for correct engine storage
instructions.
3. Coat mower's cutting blade with chassis grease
to prevent rusting.
4. Store mower in a dry, clean area.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially cables and all
moving parts.
18
Advertisement
Table of Contents
