Playback Features - Magnavox VRU364AT Owner's Manual

32
Playback l 'eatures
• olto eeeeoolileeoeoooeeeelioeeel oooeoleleeoeolloeoe • eeeooeeeeoeoeoi*,o°°-,,,,_,,°,,°°,, ...... °''°'°°°°°'''°°°°°''''''°'*'°°°''°°°°
The following playback features wall always operate:
VCR
CH. (Up/Down)
Buttons
Automatic Playback
When you put a tape in the VCR, the power will come on automatically. If the
tape's record tab is missing, playback will begin.
Automatic Rewind, Eject, Off
When a tape is played, fast forwarded, or recorded to its end, the VCR will
rewind the tape, go into the Stop mode, eject the tape, then turn itself off.
If the time counter memory is set, the VCR will only rewind to the point at
which the counter is set to zero, then stop. The VCR will not eject the tape
automatically or shut itself off.
Remote Control
0®@ 5
@@
0 0 0 O0
O0 O0
TRACKING
m (Up/Down)
Buttons
Tape Eject
A tape can be ejected with the VCR power on or off (but the VCR must be
plugged in). If a Timer Recording is programmed, a tape can only be ejected
with the power on. Make sure you insert a tape for the Timer Recording.
Auto Tracking
The VCR has automatic tracking, which continually adjusts tracking to give
you the best possible picture quality. With some recordings, however, you may
get a better picture using the manual tracking controls (see below).
Manual Tracking
To adjust the tracking manually, press the TRACKING (Up/Down) buttons on
the remote control.
NOTES:
• To return tracking to the position it was in when the VCR was shipped from
the factor_; press the CH. (Up) and CH. (Down) buttons on the VCR at the
same time. This function is controlled only by the buttons on the VCR. The
CHANNEL (Up/Down) buttons on the remote control will not adjust track-
ing.
Tracking is returned to auto tracking when a tape is inserted, or when the
STOP button is pressed to halt playback.
The CH. (Up/Down) buttons on the VCR also adjust tracking when the VCR
is in Play mode.
When the VCR is in Slow mode, auto tracking will not work. Instead, use the
TRACKING (Up/Down) buttons or the CH. (Up/Down) buttons on the VCR
to reduce noise lines in slow motion playback.
Manual tracking will not operate when the VCR is in Still mode. If you want
to reduce noise lines in a still picture, place the VCR in Slow mode. Use the
TRACKING (Up/Down) buttons to remove the noise lines. Then return to
Still mode.