Special Playback Features - Magnavox VRS960AT01 Owner's Manual

25- Special playbackfeatures tco.a d)
-_ Auto operation features J
Auto Playback
When a tape is inserted, the power comes on.
If the record tab* is removed, playback begins.
Auto Rewind, Eject Off
When a tape reaches its end during playback, fast torward, or
manual record, the VCR (Video Cassette Recorder)
automatically rewinds the tape, ejects the tape, and the VCR
turns itself off.
Memory Rewind Power Off
When the POWER button is pressed during rewind, the VCR
will turn off after rewind is complete.
"REWIND _ POWER OFF" appears on the TV screen.
Eject Cassette
A cassette may be ejected with power on or off.
* For record tab information refer to page 5.
/
VCR
CHANNEL
UP/DOWN
buttons
-_ Auto tracking control [
With Auto Tracking there is usually no need for manual
adjustments to minimize noise in playback for most tapes.
Auto Tracking continuously analyzes the signal to adjust for
optimum picture quality for each recording. However, with
some recordings you may get a better result using the
TRACKING UP/DOWN buttons.
Manual tracking controls ]
Play Tracking
When playing pre-recorded tapes or tapes recorded on units
other than your own, noise lines (black and white streaks) may
appear on the playback picture. If this occurs, adjust the
TRACKING control with the TRACKING UP/DOWN
buttons on your remote control until the streaks disappear.
To reset the tracking to its center position, press at the same
time the CHANNEL UP and DOWN buttons on the VCR.
The tracking can also be reset to its center position by pressing
the STOP button to stop the tape, and then pressing the PLAY
button.
Slow Tracking
Auto Tracking does not function in tile SIo,A mode. You can reduce
the noise lines in the slow motion picture by pressing the
TRACKING UP/DOWN buttons. This will only be necessary if
noise lines appeal. If the picture is fine, do nothing.
Note: The Manual Tracking Control will not operate in the Still
mode. If you want to reduce the noise in a Still picture, first place the
unit in the Slow mode (see page 24) and cancel the noise with the
TRACKING UP/DOWN buttons, then return it to the Still mode. A
clear picture should be obtained.
This enables you to see the picture in its entirety without distracting
noise lines.
12_rqc---II=D
r-------I _
C::! C:}.CSSi c --q
TRACKING
UP/DOWN
buttons
Remote Control
-_ Vertical hold control ]
When the picture begins to vibrate vertically,
adjust to stabilize the still picture by pressing
the TRACKING UP/DOWN buttons.
Notes:
l)This adjustment works only in the Still
mode with TRACKING UP/DOWN buttons.
2)When the picture is distorted or roils
vertically, adjust vertical hold control of your
TV.
3)Some TVs do not have a user-adjustable
vertical hold control.