Fault Codes - Fisher & Paykel DW820 Installation Instructions And User Manual

Fisher & paykel dishwasher installation instructions and user guide

Hide thumbs

Table Of Contents

Table of Contents

Fault codes

You are reminded that if you call a Fisher & Paykel Authorised Service Centre because of a User

Fault, it is not covered by the Warranty. Should you encounter any problems we recommend

that you call our Customer Care Centre.

920 model only

In the 920 Dishwasher, the Time Remaining Display informs you when there is a fault.

The fault codes are as follows and we recommend that you check the chart below and correct

if possible. If the fault code cannot be removed by pressing the POWER button, turn the

power off at the mains supply, correct the problem if possible and turn the Dishwasher on

again. If the fault code still appears, call your Fisher & Paykel Dealer or Authorised Service

Centre.

Code Description

Dishwasher

attempted to fill to

correct level but

failed.

Flood switch has

been activated.

Temperature fault.

Water temperature.

Overheating.

No increase in water

temperature during

wash cycle.

820 model only

In the unfortunate event of a fault occurring, the Dishwasher will continuously beep every

second. If the continuous beeps cannot be removed by pressing the POWER button, turn

the Power off at the mains supply, wait 10 seconds, and turn the Dishwasher on again. If the

continuous beeps still occur, call your Fisher & Paykel Dealer or Authorised Service Centre.

Possible cause

Water tap not turned on.

Too much foam.

Wash pump faulty.

Dishwasher not draining.

Flood has occurred.

Incoming water too hot.

Faulty temperature

sensor.

Faulty element.

Electronics controller

faulty.

Faulty temperature

sensor.

What to do

Turn the water tap on.

See 'Problem solving' section.