Sears LXI series 934.55116690 Owner's Manual page 28

COFYING A VIDEO iAPE
Connect the editing (recording) VCR, source (playing) VCR and your TV using the following diagram.
EXAMPLE : Recording from one VCR to another VCR.
NOTE: You can use the audio and video input jacks on the front panel of the editing (recording) VCR instead of
using jacks on the back.
AudioNideoadapter cord
(not supplied)
.
[Editing (Recording) VCR]
Coaxial cable (supplied)
[Source (Playing)VCR <Monaural>]
[TV set]
(Use for monitoring)
Antenna input jack
1) Insert a pre-recorded video cassette into the
source(playing) VCR.
2) Insert a blank video cassette, or one you want to re-
cord over, into the editing(recording) VCR cassette
compartment.
3) Press TAPE SPEED button to select the desired re-
cording speed (SLP, LP or SP).
4) Select L1 or L2 position on the editing(recording)
VCR. See page 11, under "Input Select".
5) Press REC button on the editing (recording) VCR.
6) Begin playback of the tape in the source(playing)
VCR.
NOTES:
• For best results during dubbing, use the VCR' s front
panel controls whenever possible. The remote con-
trol might affect the playback VCR's operation.
• Always use video-quality shielded cables with RCA-
type connectors. Standard audio cables are not rec-
ommended.
• You can use a video disc player, satellite receiver, or
other audio/video component with A/V outputs in
place of the playback VCR.
TO MONITOR THE RECORDING
1) Turn on the TV, and set it to the same output channel
as the editing VCR channel 3 or 4.
2) Press TV/VCR button on the editing VCR so that
"VCR" appears on the display.
- 28 - EN
6A12