Table of Contents
Advertisement
If your TV does not have A/V terminals,"
When the VCR is in the Playback mode or when the
TV/VCR button is in the VCR position, your TV will
receive the signals from the VCR on either channel 3 or
4.
To use the VCR with your TV, set the selector switch to
CH3 or CH4, whichever is not used or least used for
normal broadcasts in your area. Then set your TV to that
same channel.
CH3
CH4
I
..... ....
I
......
4
,... ju I
jacks.
NOTE: You can use the audio and video input jacks on
the front panel of VCR instead of using jacks on the
back.
[Another source]
To anaudio
output jack
[Backof theVCR]
adapter
c ord .
I out _
I
otc.
To an videooutputjack
INPUT
SELECT
To use the external input jacks, select the "LI" or "L2"
position.
If you use the audio and video input jacks on the back
of the unit, press 0, 0, 1 with number buttons to select
the "L1" position.
When you cop), a video tape, or watch a program re-
corded on an another source, use audio/video
input
If your TV has AN input jacks, you may connect your
VCR's
AUDIO/VIDEO
OUTPUT
jacks
to the
audio/video input jacks on back of your TV.
Direct audio/video connections usually result in a better
picture and sound quality for tape playback. Please see
your TV's owner's manual for A/V input connections.
AudioNideo "Y"adapter c ord
[BackoftheVCR]
I LAuDIoJ vJDEor
I
1) Open the battery compartment cover by pressing the
cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery com-
partment in the direction indicated by the polarity
(+1-) markings.
3) Replace the cover.
If you use the audio and video input jacks on the front
Note to CAT¥ system installer
o1'the unit, press 0, 0, 2 with number buttons to select
This reminder is provided to call the CATV system
the L2 position,
installer's attention to Article 820-40 of the NEC that
You can select "LI", "L2" as a channel by using the
provides guidelines for proper grounding and, in par-
CHANNEL "&," or "V" button,
ticular, specifies that the cable ground shall be con-
nected to the grounding system of the building, as
Note: "LI" and "L2" are found before the lowest memo-
close to the point of cable entry as practical.
rized channel. (Example: CH2)
EN
- 11 -
6A12
Advertisement
Table of Contents
