GE 16 Owner's Manual And Installation Instructions page 14

Installation instructions
REVERSING THE DOOR
[_] REVERSING THE DOOR HANDLES (CONT.)
5.4 Transfer Freezer Door Handle
5.4.1 Remove the screw
holding the handle
to the top of the
door and the two
screws holding the
handle to the bottom
of the door,
5.4.2 Remove the handle,
5.4.3 Remove the screw from the
right top edge of the door
and insert it into the handle
screw hole on the left side,
I 5.4.4 Transfer the door stop as shown in preceding I
section 5,2, 1
5.4.5 Attach the handle to the right
edge of the door
with screws at top and bottom,
using bottom holes vacated by
removal of the door stop
screws,
[_] RE-HANGING THE DOORS
6.1 Re-hang the fresh food door
6.1.1 Lower the fresh food door onto the
bottom hinge pin. Be sure
the washer
is in place on the pin.
Plastic
Washer
L
SWING
(CONT.)
[_]RE-HANGING THE DOORS (CONT.)
6.1.2 Insert the pin on the center hinge into the socket in the
top of the door, Place the spacer, then the washer, on the
hinge pin,
NOTE" The center hinge must
be turned over as shown when
mounted on the left side,
Washel
6.1.3
and Spacer
Tilt the door toward the cabinet, As the door is brought
into position, slide the hinge under the head of the screw
which earlier had been partly driven into the outermost
hole, Insert the remaining screw, then tighten both screws
securely
Re-hang the freezer door
Lower the freezer door '_I
onto the center hinge
pin. Be sure the Center Hinge Pin \ _
washer a.d spacer _ lk.
are in place on the pin. _
and Spacer
6.2.2 Tilt the door toward the cabinet, lifting the top hinge so
the pin fits into the socket on the top of the door,
6.2.3. Make sure the door is slightly above the top of the
cabinet and the gap between the doors is even across the
front, Tighten the top hinge screws, Do not overtighten
these screws-tighten them until they are just snug, then
turn them another one-half turn,
14