Feature: Other Data Display; Resetting To Factory Default; Capacity Remaining; Average Daily Gallons - GE GXSH40V Owner's Manual And Installation Instructions

Programming the Water Softener.
FEATURE: OTHER DATA DISPLAY
Thesemodels have an option to havethe run display
indicate different information. The information
displayed on the top half of the display can be changed
to one of the following by pressingUP ,A, or DOWN
_V buttons:
° CAPACITYREMAINING .,--
- This is the percentage of water II I II-
--I 0 °/° Remaining
/
softening capacity remaining. II IC
Days to Empty J
Immediately after a regeneration,II
lO0%shows. Aswater is used, _1 lU_g_ih_h_?eJ
the percentage wiii decrease
untiI the next regeneration. During regenerations,the
percentage increments upward.
When present time is displayed,pressthe DOWN_r'
button: % Remainingwill appear in the dispIay.The
value shown is between0 and 100percent. Thisvalue
is based on current operating capacity. Pressingthe
UP_b. button will return the screen to the previous
display.
• AVERAGE DALLYGALLONS
- Thefigure displayed is the
average gallons of water used by
the household each day over the
past seven-day period.
I _-- Average Daily 1
C 0 Go,o..
Cl =l Days to Empty
__I__IRecharge
Tonight
Pressthe DOWN_r' button again to disptaythe
Average DailyGallons.Average Daily Gallons will
appear in the dispiay.This value is updated every night
at midnight. Pressingthe UP_b. button will return the
screen to the previousdisplay.
• FLOW RATE, GPM
- When using soft water, this
display shows the flow rate
passingthrough the softener (in
gallons per minute).Zeroshows
if water is not passingthrough
the softener.
I LI.S Go,o.s/._.
--I I Days to Empty
-i!
, ,_
Pressthe DOWN_Y button again to display the flow
rate. Gallons/Min wilt appear in the display. Thisvalue
is updated every Vzsecond. Pressingthe UP ,A, button
wili return the screen to the previousdispiay. Pressing
the DOWN_F" button will return the screen to the
present time display.
RESETTING TO FACTORY DEFAULT
To reset the electronic controller to its factory
default for all settings (time, hardness, etc.):
1. Press the MODE/SET button and hold until the
display changes twice to show the flashing
mode code.
2. Press the UP _k, button to display a flashing
"SOS".
OOC
,
)
3. Press the MODE/SET button and the electronic
controller will restart.
/4.Set the present time, hardness, etc, as described
in the Programming the Water Softener section
20