Control Lockout - GE JGS968 Owner's Manual

Using the clock, timer and control lockout. GEApUionces.com
CLOCK
Make sure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing
functions to work properly. Thetime of day
cannot be changed during a timed baking
or self-cleaning cycle.
El Touch the CLOCK pad.
[] Touch the number pads.
[] Touch the STARTpad.
i¸
!iZ ¸ K,Tc.E.
ON/OFF
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
To Set the Timer
Touch the KITCHENTIMER
ON/OFF pad.
Touch the number pads until the
amount of time you want shows
in the display. Forexample, to set
2 hours and 45 minutes, touch 2, 4
and .5 in that order. If you make a
mistake touch the KITCHENTIMER
ON/OFF pad and begin again.
F-_ Touch the START pad.
After touching the STARTpad, SET
disappears; this tells you the time is
counting down, although the display does
not change until one minute has passed.
Seconds will not be shown in the display
until the last minute is counting down.
% When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHENTIMERON/OFF pad
istouched.
The 6-second tone can be canceled by
following the steps in the Specialfeatures
of your oven control section under Tones
at the End of a Timed Cycle.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the KITCHENTIMERON/OFF pad, then
touch the number pads until the time you
want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display),recall the remaining time by
touching the KITCHENTIMERON/OFF pad
and then touching the number pads to
enter the new time you want.
To Cancel the Timer
Touch the KITCHENTIMERON/OFF
pad twice.
o_r_L _ i¸
Control Lockout
Your control will allow you to lock out the
touch pads so they cannot be activated
when pressed.
To lock/unlock the controls:
El Touch the 9 and 0 pads at the same
time for 3 seconds, until the display
shows LOC ON.
r21 To unlock the control, touch
the 9 and 0 pads at the same time for
3 seconds, until the display shows
LOCOFF.
When this feature is on and the touch pads
are touched, the control will beep and the
display will show LOCON.
The control lockout mode affects all
touch pads. No touch pads will work
when this feature is activated.
The adjustment will be retained in
memory after a power failure.
15