Remote Control Battery Installation - Sanyo PLC-XU41 Owner's Manual

Part Names and Functions

Remote Control Battery Installation

Remove the battery
1
compartment lid.
Pull up and remove
the lid.
To ensure safe operation, please observe the following precautions :
– Use (2) AAA, SUM-4 or R03 type alkaline batteries.
– Replace two batteries at the same time.
– Do not use a new battery with a used battery.
– Avoid contact with water or liquid.
– Do not expose the remote control to moisture, or heat.
– Do not drop the remote control.
– If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
– Risk of explosion if battery is replaced by an incorrect type.
– Dispose of used batteries according to the instructions.
12
Slide the batteries into
2
the compartment.
Two AAA size batteries
For correct polarity (+ and
–), be
terminals are in contact
with pins in compartment.
Replace the compartment
3
lid.
sure battery