Sanyo PJ-Net Owner's Manual page 19

2
Configuration for IP Address/ Sub net/ Gateway*/DNS*
Press SELECT button again, the following network setting menu appears on the
screen. Enter the specified network address.
3
Restart the Network Unit
Select Set with 7 8 keys and press SELECT button again. The network configu-
ration display disappears and the network unit begins restarting. It takes about 40
seconds. Do not turn off the mains switch during this period.
Completing of installation
Now the installation is completed. The IP address of this projector is set to
"192.168.1.201".
* In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0]. If you do not use the functions E-mail or DNS server, it is also set
[0.0.0.0] for the DNS address.
How to enter the numbers
There are 2 ways to enter the num-
bers, one is by using the point buttons
(d e 7 8) on the remote control
handset or on the projector, the other
is by using the screen 10-key pallet by
which the numbers can be entered
directory. For further information see
next page.
Network configuration
Network Unit
OWNER'S MANUAL
19