GE 21 Owner's Manual page 18

Installatio
I str ct"
S
Refri erator
Models 21 and 25
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
in Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliences.ce
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT-save these
instructions for local
inspector's use.
•I M PORTANT-Observe all
governing
codes and
ordinances.
• NotetoInstaller - Be sure toleave these instructions with
theConsumer.
• NotetoConsumer - Keepthese instructions for future
reference.
• Skill level- Installation of this appliance requires basic
mechanical skills.
• Completion time- Refrigerator Installation
20 minutes
Water Line Installation
S0 minutes
Anti-Tip Bracket Installation
20 minutes
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer
drawer
can be removed.
• To remove the refrigerator door, see Step I in the
Reversingthe Door Swing section.
• To remove the freezer drawer, see the Removingthe
FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
(ON SOME MODELS)
If the refrigeratorhasanicemaker, i twill have
to beconnected to a coldwater line.A GEwatersupplykit
(containing tubing,shut-offvalve, f ittingsand instructions)is
available at extracostfrom
your dealer, b yvisitingourWebsiteat GEAppliances.com (in
Canada at www.GEAppliances.ca) or from Parts and
Accessories, 800.626.2002 ( InCanada1.800.661.1616).
MATERIALS YOU MAY NEED (not included)
Lag Bolts
Drill Bit Appropriate for Anchors
Anchor Sleeves
For Anti-Tip Bracket Mounted on CONCRETEFloors Only
TOOLS YOU MAY NEED
Adjustable Wrench
3/8" and 5/16" Socket
Ratchet/Driver
1/4" Outer Diameter
Compression Nut
and Ferrule (sleeve)
(icemaker models only)
Phillips-Head Screwdriver
3/32", 1/8" and 1/4" Allen
wrenches
1/8" Drill Bit and
Electric or Hand Drill
Tape measure
Pencil
1/4" Nut Driver
Wire Cutters
Level
18