Reversing The Door - GE GTDS855ED0MC Owner's Manual

About reversing the door.
Reversing the Door
Tools needed:
• Standard #2 Phillips screwdriver
• Tape-tipped putty knife
• Small flat blade screwdriver
F_ Loosen the bottom 2 right side hinge screws. Remove the
door and place it on a protected flat surface to avoid any
damage. Remove both the Blind Plate and the Strike
Plate and install them in opposite positions.
Blind plate
Before you Start
Unplugthe dryerfrom its electricaloutlet.
r_ open the door approximately 170 degrees. With a putty
knife, remove the 4 plastic covers located along the left
side of the front panel and set them aside.
Plastic Cover (4)
/
[-_ Remove the bottom screw from each hinge (right side)
and partially insert them into the top left side hinge
holes.
NOTE: All 4 front panel hinge screws will now be in the top
hinge holes- 2 on the left and 2 on the right.
.... ?)
Strike p ,---
[_] Remove the 4 door hinge screws, 4 edge screws, and 8
inside screws. Lift the inner door upwards using a flat
blade screwdriver.
Inside screws
I :
Edge
screws
12