Self-Cleaning - GE Appliances Quickset III Owner's Manual

GEAppliances.com
0
¢ self-h
LCleo
• •
LTim%; L_stor
How to Delay the Start of Self-Cleaning _onsome models)
Hake sure the clock shows the correct time of
day.
[7] Latch the door.
[_ Touch the Self Clean pad.
[_ Using the + or- pads, enter the desired
clean time.
The display will show the start time. It will not
be possible to unlatch the oven door until the
temperature drops below the lock temperature.
The oven shuts off automatically when the
clean cycle is complete, and 0:00 will flash in
the display.
r_ Touch the Start Time or Delay Start pad.
The earliest start time you can set will
appear in the display.
[] Using the + or- pads, enter the time of
day you want the clean cycle to start.
[_
Touch the Start/On pad.
FSta rt_
LonJ
To Stop a Self-Clean
Cycle
Touch the Clear/Off pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door. You
will not be able to open the door right away
unless the oven has cooled below the locking
temperature.
After a Self-Clean
Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth offer the oven
cools.
If white spots remain, remove them with a
soap-filled steel wool pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean offer one clean cycle,
repeat the cycle.
You cannot set the oven for cooking until
the oven is cool enough for the door to be
unlatched.
While the oven is self-cleaning, you
can press the Clock pad to display the time
of day. To return to the clean countdown,
press the Self Clean pad.
Apply a small amount of vegetable oil
to a paper towel and wipe the edges of the
oven racks with the paper towel. Do not spray
with Pam®or other lubricant sprays.
21