Control Settings - GE GVS04BDWASS Owner's Manual And Installation

About the control and settings.
Auto Bev
IndicatorLight
ge.com
Control Settings
The temperature range of the beverage center/
wine chiller is intended for 40°F (4,4°C) to 60°F
(!5,6°C). The displagshows the average
temperature of the appliance.
It is normal
for the actual temperature to varg slightlg
during operation.
Auto Temperature Setting
When the appliance is plugged in or the "+" pad
is pressed, the appliance runs on the "Auto Bey"
setting of/4/4°F (6,7°C)and the "Auto Bey"
indicator light in the upper left corner stags lit.
NOTE: Display will flash when the "+" pad is
pressed.
Normal Temperature Setting
The temperature of the beverage center can
be set anywhere between 39°F (3,9°C)to 61°F
(16,1°C)bg the "+" and "-" pads.
O Press and hold the SET pad. You will hear
a series of 2 beeps.
O After the second beep, press the "+" and "-"
pads to increase or decrease the desired
temperature in increments of one degree.
During this time the displeg will flash.
Press SETto confirm gour choice. The displeg
will stop fleshing. If no confirmation is made
in ten seconds, the unit will automatically
accept gour change.
NOTE:When gou change the temperature
setting, there mag be e 5-minute delay until
the compressor starts to run.
Fahrenheit and Celsius
The temperature displeg can be changed
between Fahrenheit end Celsius bg pressing and
holding the "+" pad for approximatelg 5 seconds.
Indicator Light
The D indicator is lit when the compressor is
running to cool gour unit. It will not be lit when
the compressor is idle.
_ lnterior Light
To switch the interior light on/off, simplg press
the [] pad.
When the Beverage Center/Wine Chiller is
After plugging in the beverage center/wine
chiller and setting the desired temperature,
allow the beverage center/wine chiller to reach
the set temperature before loading gout wine.
The temperature mag take up to 12 hours to
completelg stabilize.
After loading the wine or beverages, gou mag
notice the actual temperature rise. This is normal.
The actual temperature will continue to change
as the wine and beverages are cooled to the set
temperature. The temperature mag take up to
12 hours to completelg stabilize.
A guide with wine serving temperature suggestions
is located on the inside right portion of the unit.
It gives recommended temperatures for different
wines, as well as instructions on adjusting the
temperature of the beverage center/wine chiller.
NOTE:The exterior of the cabinet mag get warm.
This is normal.
Plugged In
_o i " o oQ" "
Interior
Light
You can turn the light ON or OFF bg pushing the
light switch located on the right side of the control
panel housing. If the interior light is left on,
it will raise the inside temperature.