Controls And Features; Temperature Control; Interior Light And Switch; Glass Shelves - GE ZDBG240 Owner's Manual

Table of Contents

Advertisement

Do not install the beverage center where
Temperature
the ambient temperature will go below
control
55°F (13°C) or above 90°F (32°C).
As with any refrigeration product, there is
a slight temperature variance at different
locations within the cabinet.
The coolest area will be in the lower part
of the cabinet.
The cooler area will be in the middle
section.
The upper part of the cabinet is the
warmest section.
When the temperature is adjusted, allow
24 hours for the unit to stabilize.
The interior light makes it easy to view
Interior light
your beverage labels and enhances the
and switch
display of your collection.
Tempered glass shelves in the beverage

Glass shelves

center unit are removable for easy
cleaning or for storing larger items.
To remove a shelf, open the door
completely to avoid potential damage to
the gasket. Lift up on the back of the shelf
slightly. Tilt the shelf to one side at an
angle while pulling forward.
6
To remove, lift up on the back of
the shelf

Controls and Features

To set the control, turn it to the midpoint
setting (approximately 7ºC). Once the
beverage center is loaded, allow at least
24 hours before making any adjustments
to the initial setting.
When the switch is in the OFF position,
the light comes on only when the door
is opened. When the switch is in the ON
position, the light remains on continuously
for your maximum viewing pleasure. For
best viewing, do not store a bottle on
the top shelf directly under the light.
Remember to turn off the light when
it is no longer needed.
To replace a shelf, open the door
completely to avoid potential damage
to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wall,
placing one side onto the shelf support.
Place the other side onto the opposite
shelf support. Ensure rear locking tabs
are engaged. When installed properly,
the shelf will not slide forward when
gently pulled.
Tilt the shelf at an angle while
removing or replacing
Beverage Center
Place in slots when replacing
the shelf

Advertisement

Table of Contents
loading

Table of Contents