GE JGRP20 Owner's Manual page 33

ge.com
Possible Causes What To Do
Oisplaygoes blank A fuse in your home may be * Replace the fuse or reset the circuit breaker:
blown or the ckcuk
breaker tripped.
The clock is in the • See the Special features of your oven control section°
black-out mode.
Display flashes Power failure. * Reset the clock.
Unable toget the Oven control pads were * The BAKE and BROIL HI/LO pads must be touched at
display to show "SF" not touched properly, the same thne and held for 2 seconds.
Power outage, Power outage or surge. • Reset the clock. [f tile oven was in use, you must reset
clock flashes it by touching tile CLEAR/OFF pad, setting the clock
and resetting any cooldng fimcfion.
"Burning" or "oily" This is normal in a new oven * To speed the process, set a self clean cycle
odor emitting from
and will disappear in time. Rn a minimum of 3 hours. See the Using the
the vent self-cleaning oven section.
Strong odor Improper air/gas ratio in oven. * Adjust tile oven burner air shutter
Insulation around the inside * This is nolIlla[ ill a llew oven, and will disappear
of the oven. in thne°
Fan noise A cooling fan may turn on * This is normal. The tim will run until the flmcfion
and off automatically, is over or the door is opened.
Cannotsee flames on botb Bright glow of ignker makes _' See the Broiling section.
sides of broil burner flames difficult to see.
Burners have yellow or
yellow-tipped flames
Combustion quality of
burner flames needs to be
determined visually.
* Use tile illustrations below to determine if your
burner flames are normal. If burner flames look
like A, call for service. Normal burner flames should
look like B or C, depending on the type of gas you
use. With LP gas, some yellow tipping on outer cones
is normal.
A-Yellow flames B-Yellow tips C-Soft blueflames
Callfor service on outercones Normal for natural
Normal for LPgas gas
33