GE Appliances JGBS04 Owner's Manual And Installation Instructions page 49

GEAppliances.com
Possible Causes What To Do
Excessivesmoking Excessive soil. , Touch the Clear/Off pad. Open the windows to
rid the room of smoke. Wait until the LOCKEDDOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not open Oven too hot. . Allow the oven to cool below locking temperature.
after a clean cycle Do not lock the door with the door latch except when
using the self-clean feature.
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning upper oven section.
clean cycle Oven was heavily soiled. , Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"Door" appears in the Latch handle was moved to the , Move the latch handle to the right only when setting
display (on models right but a program other than the self-cleaning cycle.
with a door latch) self-clean was selected.
"LOCK DOOR"flashes
in the display
LOCKED DOOR light
is on when you want
to cook
"F--and_
lette¢' flash in the display
Oven shelves are
difficult to slide
"Probe" appears in
the display (some models)
Water remaining on
oven floor after steam
clean cycle
The self-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
way to the right.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
. Close the oven door and on models with a latch, move
the latch all the way to the right.
. Touch the Clear/Off pad. Allow the oven to cool
and then, on models with a door latch, unlock the door.
m m
• The latch may have been moved, even if only slightly,
from the locked position. Make sure the latch is moved
to the right as far as it will go.
You have a function error code. . Touch the Clear/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. . Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
The nickel shelves (if so equipped) , Apply a small amount of vegetable oil to a paper
were cleaned in a self-clean cycle, towel and wipe the edges of the oven shelves with
The gray porcelain-coated shelves the paper towel. Do not spray with Pam®or other
(if so equipped) were improperly lubricant sprays.
cleaned.
This is reminding you to enter a , Entera probe temperature.
probe temperature after plugging
in the probe.
This is normal
. Removeany remaining water with a dry cloth or sponge.
49