Initial Selections; Selecting The Input Signal - Panasonic TH-50VX100W Operating Instructions Manual

Press the
Power Indicator: Red (standby)
Press the
Power Indicator: Green
Turn the power to the Plasma Display off by pressing the
the Plasma Display is on or in standby mode.
Note:
During operation of the power management function, the power indicator turns orange
in the power off state.

Initial selections

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
INPUT
INPUT
HDMI1
HDMI2
HDMI3
HDMI4
COMPONENT
PC
Using dedicated buttons for input selection
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the
SLOT.
• Select to match the signals from the source connected to the component/RGB
input terminals. (see page 38)
• Image retention (image lag) may occur on the plasma display panel when a still
picture is kept on the panel for an extended period. The function that darkens
the screen slightly is activated to prevent image retention (see page 45), but this
function is not the perfect solution to image retention.
button on the remote control to turn the Plasma Display off.
button on the remote control to turn the Plasma Display on.
Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
HDMI signal terminal in SLOT1
HDMI signal terminal in SLOT2
COMPONENT or RGB signal terminal in SLOT3
PC signal terminal in PC IN
Press to select HDMI signal terminals 1–4 in SLOT 1 and 2.
Press to select component or RGB signal terminal in SLOT 3.
Press to select PC signal terminal in PC IN.
Power On / Off
switch on the unit, when
■
INPUT MENU ENTER/
INPUT MENU
HDMI
PC PC COMPO. COMPO.
HDMI HDMI
CH CH INPUT INPUT
DISPLAY
■
ENTER/
13