Table of Contents
Advertisement
Initial selections
Selecting the input signal
Select the input signals to be connected by installing the optional Terminal Boards.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input terminals. (see page 37)
• In two-screen display, the same input mode cannot be selected for the main picture and sub picture.
• Image retention (image lag) may occur on the plasma display panel when a still picture is kept on the panel for an
extended period. The function that darkens the screen slightly is activated to prevent image retention (see page 47),
but this function is not the perfect solution to image retention.
Selecting the On-Screen Menu Language
14
Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1
INPUT2
Press the INPUT "1", "2", "3" or "PC" input mode selection
button to select the input mode.
This button is used to switch directly to INPUT mode.
These buttons can only display the slot which is installed.
If you press the button whose slot is not installed, it
automatically displays the current input signal.
When a dual input terminal board is attached, A or B is
displayed depending on the selected input signal. (Ex.
INPUT1A, INPUT1B)
Press to display the Setup menu.
Press to select the OSD Language.
Press to select your preferred language.
Selectable languages
English(UK)
Deutsch
Français
Italiano
INPUT3
PC
Español
ENGLISH(US)
.......(Chinese)
.......(Japanese)
INPUT
MENU
-/
VOL
+
/
ENTER/
+
INPUT
MENU
-/
VOL
/
Setup
Signal
Screensaver
Component/RGB-in select
RGB
Input label
PC
Power save
Off
Off
Standby save
Off
Power management
Off
Auto power off
English ( UK )
OSD Language
ENTER/
1/2
Hide quick links:
Advertisement
Table of Contents
