Panasonic TH-50VX100W Operating Instructions Manual page 31

● Dot Clock
(During "Component", "RGB" and "PC" input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed.
If this happens, adjust so that any such noise is minimized.
● Clock Phase
(During "Component", "RGB" and "PC" input signal)
Eliminate the flickering and distortion.
● 1:1 Pixel Mode
Adjusts the display size when 1125i, 1125p or 1250i signal is input.
Notes:
•
•
•
•
● 1:1 Pixel Mode
When the input signal is a 2k1k signal (2048 × 1080 / 24p, 2048 × 1080 / 24sF), the display
size is adjusted as follows.
(2k1k)
(For 2k1k signals)
Note:
2k1k signals can only be received when the Dual Link HD-SDI Terminal Board (TY-FB11DHD)
is installed.
● Display size
Adjusts the image display size on screen.
Off: Sets the normal image display size on screen.
On: Sets the image display size approximately 95 % of the normal image display.
Notes:
•
•
•
•
Helpful Hint (
Normalise
While the Pos. /Size display is active, if the OK button is pressed during "Normalise", then all adjustment values
are returned to the factory settings.
Select On when you would like to replay 1920 × 1080 input signal.
Applicable input signal;
1125 (1080) / 50i • 60i • 24sF • 24p • 25p • 30p • 50p • 60p, 1250 (1080) / 50i
Select Off when flickering is shown around the image.
H-Size, V-Size and Dot Clock cannot be adjusted when On is selected.
Off
Off
Off
"Display size" can be modified when "Studio mode" in the Options menu is "On". When
"Studio mode" is "Off", this setting is "Off" and cannot be changed. (see page 41)
This setting is valid only when the input signals are as follows;
525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p,
1125/24p, 1125/30p, 1125/60p, 1125/50p, 1250/50i (Component Video, RGB, DVI, SDI,
HDMI)
When "Display size" is set to "On", "H-Pos" and "V-Pos" in "Pos. /Size" can be adjusted.
Refer to each board's operating instruction for DVI, SDI, HDMI's corresponding signals.
Normalization)
On
On (left) On (Centre)
On
Adjusting Pos. /Size
On (Right)
31