Touch Panel Assembly - Panasonic TY-TP42P30K Operating Instructions Manual

Touch Panel Assembly

Note
Place the touch panel making its front surface face down on a clean cloth or blanket to prevent the front
•
surface of the touch panel from getting scratched or dirty during work.
Mounting in horizontal posture
Attach the mounting brackets A (for top and bottom sides) to the touch panel with the mounting screws A (2 each).
See the gure below for the screw holes of attachment positions.
The procedure for vertical posture is the same.
Attachment positions
(8 holes without screws in them)
Mounting in vertical posture
Check in the gure below the positions where the brackets are attached, and remove the screws (8 in total from top and bottom sides).
Attach the mounting brackets A (for top and bottom sides) with the mounting screws A (2 each) to the screw
holes from which the screws were removed.
Notes
For screw holes of other models than 42V, see "Drawing of Screw Holes" (page 14).
•
Keep the screws which were removed.
•
Mounting screw A
Mounting screw A
Top side (42V)
1 2
Bottom side (42V)
1 2
3 4 5 6
3 4 5
Mounting
bracket A
(for top side)
Mounting
bracket A
(for bottom
side)
5