Inventory - Grizzly G0682 Owner's Manual

inventory

The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Container 1: (figure 3)
A. saw (not shown) ......................................... 1
b. Work stop assembly .................................. 1
C. roller assembly ......................................... 1
D. handle assembly ....................................... 1
Container 2: (figure 4)
E. stand rear panel ....................................... 1
f.
stand side panels ...................................... 2
G. stand Front panel ...................................... 1
hardware: (Not Shown)
hex bolts m8-1.25 x 20 (stand) ...................... 12
hex Nuts m8-1.25 (stand) ............................... 12
hex bolts m8-1.25 x 35 (saw mounting) ........... 4
Flat Washers 8mm (stand, saw mounting) ..... 28
NOTICE
If you cannot find an item on this list, check
the mounting location on the machine or the
packaging materials. Sometimes parts are
pre-installed for shipping, or they become
hidden by packaging materials.
-12-
b
Qty
figure 3. machine inventory.
e
g0682 12" Cold Cut saw (mfg. since 12/10)
d
g
figure 4. stand inventory.
C
F