Grizzly G0698 Owner's Manual page 35

3.
Figure 45
Figure 45. Lathe prepared for outboard turning.
Keep the lathe tool resting on a tool rest
the ENTIRE time that it is in contact with
workpiece or when preparing to make con-
tact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands into the workpiece.
Failure to heed this warning could result in
serious personal injury.
4.
Sanding/Finishing
46
Figure 46.
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Wrapping the sandpa-
per completely around
the workpiece could pull
your hands into the mov-
ing workpiece and may
cause
Never wrap sandpaper
or finishing materials
completely around the
workpiece.
Figure
serious injury.