Grizzly G0698 Owner's Manual page 32

4.
5.
6.
Figure 41
Figure 41.
7.
Installing/Removing Headstock Center
Page 22
Note: Use the tool rest to support the opposite
end of the workpiece so that the workpiece
and spur center do not separate.
Step 1
8.
9.
10.
Do not press the workpiece too firmly with
the tailstock or the bearings will bind and
overheat. Likewise, do not adjust too loosely
or the workpiece will spin off the lathe. Use
good judgment and care, otherwise, serious
personal injury could result.
11.
Page 21
12.
Keep the lathe tool resting on the tool
rest the ENTIRE time that it is in contact
with workpiece or when preparing to make
contact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands with the workpiece.
Failure to heed this warning could result in
serious personal injury.
Page 23