Mazda CX-9 Owner's Manual page 453

CX-9_8CM9-EA-12I_Edition1 Page453
Thursday, September 13 2012 2:39 PM
NOTE
Make sure the jack is well lubricated before
l
using it.
(With Tire Pressure Monitoring System)
Be sure to register the tire pressure sensor
l
ID signal code whenever tires or wheels are
changed (page 5-32).
1. Park on a level surface off the right-of-
way and firmly set the parking brake.
2. Shift into Park (P) and turn off the
engine.
3. Turn on the hazard warning flasher.
4. Have everyone get out of the vehicle
and away from the vehicle and traffic.
5. Remove the jack, tool, and spare tire
(page 7-3).
6. Block the wheel diagonally opposite
the flat tire. When blocking a wheel,
place a tire block both in front and
behind the tire.
NOTE
When blocking a tire, use rocks or wood blocks
of sufficient size if possible to hold the tire in
place.
Form No.8CM9-EA-12I
Black plate (453,1)
In Case of an Emergency
qRemoving a Flat Tire
1. Loosen the lug nuts by turning them
counterclockwise one turn each, but do
not remove any lug nuts until the tire
has been raised off the ground.
2. Place the jack on the ground.
3. Turn the jack screw in the direction
shown in the figure and adjust the jack
head so that it is close to the jack-up
position.
Jack head
Flat Tire
7-9