Operation Using Advanced Key Functions - Mazda CX-9 Owner's Manual

CX-9_8CM9-EA-12I_Edition1 Page99
Thursday, September 13 2012 2:34 PM
NOTE
In extremely cold weather or after the
l
vehicle has not been driven in several days,
let the engine warm up without operating
the accelerator.
Whether the engine is cold or warm, it
l
should be started without use of the
accelerator.
Turning the engine off
1. Move the shift lever to the P position.
2. Switch the ignition from ON to ACC.
NOTE
When the engine is turned off and the ignition
is switched from ACC to OFF, the KEY
indicator light (green) flashes in the instrument
cluster for about 30 seconds if the battery
power of the advanced key is low. Replace the
battery with a new one.
Refer to Battery Replacement (page 3-7).
3. Push in the start knob from the ACC
position and turn it to the OFF.
CAUTION
When leaving the vehicle, make sure
the ignition is switched to OFF.
NOTE
When switching the ignition to OFF, the
l
ignition switch has to be pushed in from the
ACC position and turned. Without being
pushed in, the ignition switch stops at the
ACC position and the vehicle battery may
be discharged if the ignition switch is left in
the ACC position. When leaving the vehicle,
make sure the ignition is switched to OFF.
If the vehicle is left with the ignition not
l
switched to OFF, a beep sound is heard and
the indicator light flashes to notify the
driver.
Refer to Warning Beep (page 3-18).
Form No.8CM9-EA-12I
Advanced Keyless Entry and Start System
Operation Using Advanced
Key Functions
qKeyless Entry System
This system uses the more traditional
keyless entry buttons to remotely lock and
unlock the doors and the liftgate, and
opens the power windows and the
moonroof.
It can also help you signal for attention.
Press the buttons slowly and carefully.
NOTE
The keyless entry system is designed to
l
operate up to about 2.5 m (8 ft) from the
center of the vehicle, but this may vary due
to local conditions.
The system does not operate when the
l
auxiliary key is in the ignition switch.
With the start knob in the OFF position, the
l
system is fully operational. If the ignition is
not switched off or the start knob is pushed
in, the system does not operate.
All doors and the liftgate cannot be locked
l
by pressing the lock button while any door
or the liftgate is open. The hazard warning
lights will also not flash.
If the transmitter does not operate when
l
pressing a button or the operational range
becomes too small, the battery may be
dead. To install a new battery, refer to
Maintenance (page 3-5).
Black plate (99,1)
Knowing Your Mazda
3-13