Mazda CX-9 Owner's Manual page 263

CX-9_8CM9-EA-12I_Edition1 Page263
Thursday, September 13 2012 2:36 PM
5. Press and hold the just-trained
HomeLink button and observe the
indicator light.
If the indicator light stays on constantly,
programming is complete and your
device should activate when the
HomeLink button is pressed and released.
NOTE
To program the remaining two HomeLink
buttons, begin with Programming
Do not repeat step 1.
If the indicator light blinks rapidly for
two seconds and then turns to a
constant light, continue with
Programming steps 6 8 to complete
the programming of a rolling code
equipped device (most commonly a
garage door opener).
6. At the garage door opener receiver
(motor-head unit) in the garage, locate
the learn or smart button. This can
usually be found where the hanging
antenna wire is attached to the motor-
head unit.
7. Firmly press and release the learn or
smart button. (The name and color of
the button may vary by manufacturer.)
NOTE
There are 30 seconds in which to initiate step
8.
8. Return to the vehicle and firmly press,
hold for two seconds and release the
programmed HomeLink button. Repeat
the press/hold/release sequence a
second time, and, depending on the
brand of the garage door opener (or
other rolling code equipped device),
repeat this sequence a third time to
complete the programming process.
Form No.8CM9-EA-12I
Switches and Controls
HomeLink should now activate your
rolling code equipped device.
NOTE
To program the remaining two HomeLink
buttons, begin with Programming
Do not repeat step 1.
For questions or comments, please contact
HomeLink at www.homelink.com or 1-
800-355-3515.
step 2.
Gate operator/Canadian Programming
Canadian radio-frequency laws require
transmitter signals to time-out (or quit)
after several seconds of transmission
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are
designed to time-out in the same
manner.
If you live in Canada or you are having
difficulties programming a gate operator
by using the Programming procedures
(regardless of where you live), replace
Programming HomeLink step 3 with
the following:
NOTE
If programming a garage door opener or gate
operator, it is advised to unplug the device
during the cycling process to prevent
possible overheating.
Continue to press and hold the HomeLink
button while you press and release
every two seconds ( cycle ) your hand-
held transmitter until the frequency signal
has successfully been accepted by
HomeLink. (The indicator light will flash
slowly and then rapidly.) Proceed with
Programming step 4 to complete.
Black plate (263,1)
Driving Your Mazda
step 2.
5-87