Registering Preset Codes - Marantz SR5006 Owner's Manual

Registering preset codes

When preset codes are registered in the included remote control unit,
it can then be used to operate any devices you have, such as DVD
players or TVs made by different manufacturers.
NOTE
BD DVD SAT
• No preset codes other than , , and
• In the factory settings, remote control codes for all marantz products
are registered.
n Buttons used for operating the devices
SOURCE Z / X
q
For switching power of each device on or off.
uio p ENTER
,
w
For menu operation of each device.
MENU SHIFT/TOP MENU
,
e
For displaying the menu of each device.
3 1 2 8 9 6 7
, , , , , ,
r
0 9 +10
t Number button ( – , )
PRESET + PRESET –
y ,
TV Z / X TV INPUT
,
u
For operating a TV
This button is enabled in any mode.
For details on operation with the remote control unit, see pages
30, 32, 36, 42, 44, 46, 48, 50, 115, 116.
Registering preset codes
The following two methods can be used for registering the reset code.
q Entering a 4-digit code
w Scanning the code table
TV
can be registered.
q Entering a 4-digit code
See the preset code list table for the code to be input.
1
Press and hold down the input
source select buttons for the
appliance to control, and press
SET until the SEND indicator
blinks.
2
Press the 4-digit code for the
appliance using
at the end of this manual).
When the procedure is successful, the
LEARN indicator blinks twice.
NOTE
If the LEARN indicator did not blink twice,
then repeat steps 1 and 2 and try entering
the same code again.
0 9
– (code table
113
w Scanning the code table
1
Switch the power of the appliance
to which you want to register the
preset code to ON.
2
Press and hold down the input
source select buttons for the
appliance to control, and press
SET
until the SEND indicator
blinks.
3
Aim the remote control at the
appliance and slowly alternate
SOURCE d
between pressing and
SOURCE Z /X for the appliance.
4
When the power of the appliance
that you want to register has
turned off, release the button.
5
ENTER
Press .
When the procedure is successful, the
LEARN indicator blinks twice.
vSee overleaf