Installing A Trimmer Head - Shindaiwa C282 Owner's/Operator's Manual

Assembly (continued)
Cutting Attachment Shield
1. Insert the cutting attachment shield
between the outer tube and the cut-
ting attachment mounting plate.
NOTE:
It may be necessary to loosen the
retaining nut and clamp screw to adjust
cutting attachment shield mounting
plate.
2. Fit the two spacers and the bracket
over the outer tube and loosely
install the four socket-head screws.
3. Tighten the four socket-head cap
screws to secure the cutting attach-
ment shield.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket-
head cap screws.
WARNING!
NEVER operate the unit
without the cutting attachment
shield installed and tightly secured!

Installing a Trimmer Head

NOTE:
This unit is shipped with Holder A,
Holder B, shaft bolt, and bolt guard
installed. The shaft bolt is a LEFT-
HAND thread. Remove it by turning
CLOCKWISE!
1. With the gearcase output shaft facing
up, rotate the gearshaft and Holder A
until the hole in Holder A aligns with
the matching hole in the gearcase
flange, and then lock the holder to
the gearcase by inserting the long
end of the hex wrench through both
holes.
2. Using the combination spark plug/
screwdriver wrench, remove the
shaft bolt, and bolt guard. (The bolt
guard and shaft bolt are not used
with a trimmer head).
8
Socket-Head
Cap Screws
Spacer
Cutting attachment shield assembly
Sub-Shield (when trimmer head is in use)
1. Attach the shield extension to the cut-
ting attachment shield.
WARNING!
NEVER use this machine
without sub-shield when using a
trimmer head.
CAUTION!
Make sure the sub-shield is com-
pletely hooked at the hook receiver.
Shaft Bolt
Bolt Guard
Gear Shaft
3. Using the hex wrench to secure
Holder A, install and hand-tighten
the trimmer head (counter-clockwise
to install).
4. Remove the hex wrench from the
gearcase and holder.
Bracket
Spacer
Retaining
Mounting Plate
Nut
Cutting Attachment Shield
Sub-shield
Attach the shield extension to the cutting
attachment shield
Hand-tighten Trimmer Head (counter-
Holder B
Holder A
Hex Wrench
This unit is now completely
assembled and ready to use as
Outer Tube
Cutting Attachment
Shield w/subshield
Hook Receiver
Hook
clockwise to install)
a trimmer.