Figure 3-10 Mounting Screw Clearance For The Maxtor Hard Disk Drives - Maxtor MaxLine Plus II 250GB AT Product Manual

5.0 mm Maximum
(0.198 Inches)
Figure 3-10
CAUTION:
Drive
Mounting
Screw
Printed-
Circuit
Board
Head/Disk
Assembly
Mounting Screw Clearance for the Maxtor Hard Disk Drives
The PCB is very close to the mounting holes. Do not exceed
the specified length for the mounting screws. The specified
screw length allows full use of the mounting hole threads,
while avoiding damaging or placing unwanted stress on the
PCB. Figure 3-10 specifies the minimum clearance between
the PCB and the screws in the mounting holes. To avoid
stripping the mounting hole threads, the maximum torque ap-
plied to the screws must not exceed 8 inch-pounds. A maxi-
mum screw length of 0.25 inches may be used.
6.35 mm Maximum (0.25 Inches)
Printed-
Circuit
Board
Maxtor MaXLine Plus II 250GB AT
Installation
3-17