Regulatory Compliance Standards; Hardware Requirements - Maxtor MaxLine Plus II 250GB AT Product Manual

Versatility
• Power saving modes
• Downloadable firmware
• Cable select feature
• Ability to daisy-chain two drives on the interface
2.3

REGULATORY COMPLIANCE STANDARDS

Maxtor Corporation's disk drive products meet all domestic and international
product safety regulatory compliance requirements. Maxtor's disk drive products
conform to the following specifically marked Product Safety Standards:
• Underwriters Laboratories (UL) Standard 1950. This certificate is a
category certification pertaining to all 3.5-inch series drives models.
• Canadian Standards Association (CSA) Standard C.22.2 No. 1950. This
certificate is a category certification pertaining to all 3.5-inch series
drives models.
• TUV Rheinland Standard EN60 950. This certificate is a category
certification pertaining to all 3.5-inch series drives models.
Product EMI/EMS Qualifications:
• CE Mark authorization is granted by TUV Rheinland in compliance
with our qualifying under EN 55022:1994 and EN 50082-1:1997.
• C-Tick Mark is an Australian authorization marked noted on Maxtor's
disk drive products. The mark proves conformity to the regulatory
compliance document AS/NZS 3548: 1995 and BS EN 55022: 1995.
• Maxtor's disk drives are designed as a separate subassembly that conforms to
the FCC Rules for Radiated and Conducted emissions, Part 15 Subpart J;
Class B when installed in a given computer system.
• Approval from Taiwan BSMI. Number: 3892A638
2.4

HARDWARE REQUIREMENTS

The MaXLine Plus II 250GB AT hard disk drive is compatible with the IBM PC AT,
and other computers that are compatible with the IBM PC AT. It connects to the PC
either by means of a third-party IDE-compatible adapter board, or by plugging a
cable from the drive directly into a PC motherboard that supplies an ATA interface.
Maxtor MaXLine Plus II 250GB AT
General Description
2-3