Mounting The Drive; Figure 5. Connecting Cable-Selected Drives - Seagate Medalist Pro Series Product Manual

22 Medalist Pro 6450/5040 Product Manual, February 1997
CSEL not carried
to pin 28 of
this connector
Pin 28 grounded
at computer

Figure 5. Connecting cable-selected drives

2.5 Mounting the drive

You can mount the drive in any orientation.
Use the set of mounting guidelines below that are appropriate to the type
of mounting holes used: either bottom mounting holes or side mounting
holes. Refer to Figure 6 on page 23 for mounting dimensions.
Bottom mounting holes. Insert four 6-32 UNC screws in the four bottom
mounting holes as shown in Figure 6.
Caution. Do not insert the bottom mounting screws more than
0.20 inches (6 turns) into the drive frame.
Side mounting holes. Use four 6-32 UNC screws in four of the six
available side mounting holes as shown in Figure 6. Use two mounting
holes on each side of the drive.
Caution. Do not insert the side mounting screws more than 0.20
inches (6 turns) into the drive frame. If you use a screw that is
too long, you risk damaging the drive's circuit board.
Slave
Master
Computer