Master/Slave Configuration; Figure 4. Configuration Settings - Seagate Medalist Pro Series Product Manual

20 Medalist Pro 6450/5040 Product Manual, February 1997
Options jumper block (J5)
7 5 3 1
8 6 4
2

Figure 4. Configuration Settings

2.4.1 Master/slave configuration

Use the following settings to configure the drive as master or slave.
One drive only. The drive is configured at the factory for single-drive
operation. No jumpers are required for single-drive operation. The spare
jumper on pins 6 and 8 does not affect drive operation.
Drive as slave. Place a jumper on pins 5 and 6.
Drive as master with an ATA-compatible slave. Place a jumper on
pins 7 and 8.
Spare
Jumper
One drive only
Drive is slave
Master with an
ATA-compatible
slave
Alternate Capacity
(AC)
Cable select
Remote LED
connection
Circuit Board