Table of Contents
Advertisement
Storage
Always let the iron cool down before storing it.
1
Empty the water tank and store the supply hose and the mains cord.
2
There are hand-grips on the either side of the steam tank for easy transport.
Troubleshooting
Please check the followings before repair.
Problem
The appliance does
not become hot
The iron does not
produce any steam.
Water
droplets
come
out
of
the
soleplate
Smoke
comes
out of my new iron
when I switch it on.
The appliance
produces a pumping
sound
Possible cause(s)
There is connection problem
The steam tank has not been switched
on.
The temperature dial has been set to
MIN
There is not enough water in the
Detachable water tank
The steam pilot light is still off
The selection ironing temperature is too
low for steam ironing
The Detachable water tank has not been
properly attached to the steam tank.
When the iron has been set to a very
high temperature, The steam produced
is dry and hardly visible. It will be even
less
visible
when
temperature is relatively high and it will
be
entirely
invisible
temperature has been set to MAX.
The selected temperature is too low for
steam ironing.
When you start steam ironing and when
you have stopped steam ironing for a
while, the steam that was still present in
the supply hose will have cooled down
and condensed into water, which can
cause water droplets to come out of the
soleplate.
Some parts of the appliance have been
lightly greased in the factory and may
initially give off some smoke when
heated.
Water is being pumped into the steam
tank
Solution
Check the mains cord, the plug
and the wall socket.
Set the power switch to "on"
Set the temperature dial to the
required ironing temperature
Fill in the Detachable water
tank
Wait until the steam pilot light
goes on
Set the temperature to ●● or
higher
Attach the Detachable water
tank to the steam station
properly
Set the iron to a lower
temperature, e.g. ●●, to check
if the iron is actually producing
the
ambient
steam.
when
the
Set the temperature higher than
●●
This is perfectly normal. Hold
the iron over an old cloth and
press the steam activator when
you start ironing (again).Wait
until steam instead of water
comes out of the soleplate.
This phenomenon is perfectly
normal and will cease after a
short while
This is normal
Advertisement
Table of Contents
