Table of Contents
Advertisement
TROUBLESHOOTING
Problem
No steamproduced
Leaking
Flakes and
impurities coming
out
Possible cause
Iron has cooled
Steam control set to 0
Water tank empty
Low temperature (below
2)
Steam or steam boost
being used at low
temperature
Steam burst
functionhas been
overused
Water tank overfilled
Fill opening not closed
properly
Iron has not been
descaled
Solution
Allow iron to heat up in base until
indicator light goes away
Set the steam control to a right steam
setting which can produce the steam as
per above stated using methods.
Fill water tank
Raise thermostat dial
Allow iron to heat up in base
Allow iron to heat up in base and use
team burst function less
Do not fill beyond MAX level
Close fill opening properly
Descale as per Cleaning & Care
Advertisement
Table of Contents
