Table of Contents
Advertisement
Preparing for use
Filling Water
● If the tap water in your area is very hard, we advise you to mix the tap water with a equal
amount of deminerialized water.
● Do not put perfume, vinegar, starch, descaling agents, ironing aids, other chemicals or 100
percent distilled water in the detachable tank(H).
1
Pull down the Detachable water tank locker (W).
2
Remove the detachable water tank (H) from the steam station.
3
Fill the detachable water tank with water up to the MAX indication.
4
Pull down the Detachable water tank locker(W).
5
Slide the detachable water tank (H) back into the steam station.
● The detachable water tank (H) can be refilled at any time during use.
● This appliance has a built-in water level sensor. When the minimum level in the detachable
water tank (H) has been reached, the water tank lower water indicator light (P) will start
flashing. Steam ironing will not be possible！
Note:
When you use the appliance for the first time or after Calc Clean, a lot
of water will be pumped from the detachable water tank into the steam
station.
Refill the tank, if necessary.
Setting the temperature
Check the garment label for the required ironing temperature
●
Synthetic fabrics (e.g. acrylic, viscose, polyamide) and silk
●●
Wool
●●●
Cotton
MAX
Linen
1
Set the temperature control dial (S) to the required ironing temperature by turning it to
the appropriate temperature indication.
2
Insert the main plug (U) into an earthed wall socket and press the power indicator.
The steam station and the iron will now start heating up.
The iron takes approx. 1 minute to heat up to ●● and the steam station takes approx. 2
minutes to heat up.
As soon as the steam station has reached its maximum pressure level and is ready for
steam ironing, the steam indicator light (Q) goes on.
Advertisement
Table of Contents
