IBM System x3650 M3 4255 Installation And User Manual page 70

v The system scans devices in the following order, if you have not changed the
The following illustration shows the adapter connectors on the PCI riser-card
assembly.
To install a PCI adapter, complete the following steps:
54
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
If you install a different supported riser-card assembly, the supported adapter
types might be different. For a list of supported riser-card assemblies, see
http://www.ibm.com/servers/eserver/serverproven/compat/us/.
default boot precedence:
– Video Unified Extensible Firmware Interface (UEFI) (fixed)
– System board Ethernet 1 PXE (fixed)
– System board Ethernet 2 PXE (fixed)
– System board SAS (or RAID)
Adapter
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 37.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see "Turning off the server" on page 22).
3. Remove the cover (see "Removing the cover" on page 45).
4. Determine which expansion slot you will use for the adapter.
5. If you are installing an adapter in PCI expansion slot 1 or 2, remove PCI
riser-card assembly 1; if you are installing an adapter in PCI expansion slot 3
or 4, remove PCI riser-card assembly 2. See "Removing a PCI riser-card
assembly" on page 46.
6. Slide the expansion-slot cover out of the PCI riser-card assembly expansion
slot.
PCI
riser-card
assembly
Adapter
connectors