Assembly - Jet EQUIPMENT & TOOLS “W” Series Operator's Manual

Assembly

Note: Individual pallet trucks are assembled and ready to use. Pallet trucks purchased in crate
quantities (6 units to a crate) require some assembly. Match the "letter" label on the handle
assembly to the "letter" label on the frame, prior to assembly.
Tools Required for Assembly:
Hammer
3mm Hex Wrench
Pliers
To attach handle assembly to the frame:
1. Unscrew the hex socket screw.
6. Tap out pump retainer pin.
2. Tap out pivot pin.
7. Feed the chain through
the hole in the pivot pin.
5
3. Align the holes in the handle with
the holes in the pump body. Tap
the pivot pin into the handle and
pump body.
4. Using pliers, turn the pivot pin until
spring pin hole's line up.
5. Using a hammer, tap the spring pin
into the pump body and pivot pin.
Reinstall the hex socket screw.
8. Place the bottom of the head
through the lowering valve.