Table of Contents
Related Manuals for Jet PTW-2036
Summary of Contents for Jet PTW-2036
- Page 1 This .pdf document is bookmarked Operating Instructions and Parts Manual PTW Series Premium Pallet Trucks 427 New Sanford Road LaVergne, Tennessee 37086 Part No. M-140170 Ph.: 800-274-6848 Revision D 09/2018 www.jettools.com Copyright © 2017 JET...
-
Page 2: Warranty And Service
JET sells through distributors only. The specifications listed in JET printed materials and on official JET website are given as general information and are not binding. JET reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason ®... -
Page 3: Table Of Contents
Table of Contents Section page Warranty and Service ............................2 Table of Contents ..............................3 IMPORTANT SAFETY INSTRUCTIONS ......................4 Introduction ................................4 Specifications ................................ 5 Assembly ................................6 Operation ................................7 Lubrication ................................7 Maintenance ................................8 O-Ring and Seal Replacement for Ram Piston and Plunger Piston ..............8 O-Ring and Seal Replacement for Valve Cartridge ................... -
Page 4: Important Safety Instructions
Introduction To better understand the proper use and safe operation of your JET PTW Series Premium Pallet Truck, please take a few minutes to carefully read and follow the instructions contained in this manual. When finished reading and understanding the manual, please file in a safe and convenient location for the life of the pallet truck. -
Page 5: Specifications
Ram/Pump piston outside diameter: 1.24 / 0.71 in. Figure 1 The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 6: Assembly
Assembly Note: Individual pallet trucks are assembled and ready to use. Pallet trucks purchased in crate quantities (6 units to a crate) require some assembly. Match the “letter” label on the handle assembly to the “letter” label on the frame, prior to assembly. Tools required for assembly: Hammer Pliers... -
Page 7: Operation
Operation To raise the forks, push lever down and pump the handle until desired height is reached. To lower forks, pull lever up. The lever is spring loaded and will return to the neutral position when released. To freely move the handle, set the lever in the center neutral position. -
Page 8: Maintenance
Also, certain procedures may require specialized Refill oil to correct level (80% capacity or tools. You can locate the nearest authorized JET approximately 2 inches deep in reservoir), and Service Center on our website: www.jettools.com. -
Page 9: Replacement Parts
Number of your machine available when you call will allow us to serve you quickly and accurately. Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET. Some parts are shown for reference only, and may not be available individually. - Page 10 Parts Breakdown for PTW Series Pallet Trucks...
- Page 11 Parts List for PTW Series Pallet Trucks Index No. Part No. Description Size 1 ....PT2036-1-1 ....Handle Assembly ................... 1 2 ....PTX2748-002 .... Spring Pin ..............Ø4×30mm ..... 1 3 ....PT2036-1-3 ....Spring for Lowering Lever ................1 4 ....
- Page 12 65 ....PT2036-2-6 ....UHS Seal *............... Ø18mm ......1 66 ....PTW-66 ..... Pump Retainer Pin ..................1 67 ....PT2036-3-36G ..Fork Frame for PTW-2036 ................1 ....PT2042-3-36G ..Fork Frame for PTW-2042 ................1 ....