Ryobi RY29550 Operator's Manual page 9

REMOVINg THE ATTAcHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
 Loosen the knob.
 Push in the button and twist the shafts to remove and
separate ends.
ATTAcHINg THE HANgER cAP
See Figure 3.
There are two ways to hang your attachment for storage.
 To use the hanger cap, push in the button and place the
hanger cap over end of the lower end attachment shaft.
Slightly rotate the cap from side to side until the button
locks into place.
 The secondary hole in the attachment shaft can be used
for hanging purposes as well.
ATTAcHINg THE FRONT HANDLE
See Figure 4.
 Remove wing nut, washer, and bolt from the front
handle.
 Install the front handle onto the top side of the drive shaft
housing.
NOTE: The open side of the handle should face the
operator.
 Place the bolt through the front handle.
NOTE: The hex bolt head fits inside the hex recess molded
into one side of the handle.
 Reinstall the washer and wing nut.
 Tighten wing nut securely.
WARNINg:
The line cutting blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
ATTAcHINg THE gRASS DEFLEcTOR
See Figure 5.
 Remove the wing screw from the grass deflector.
 Insert the tab on the mounting bracket in the slot on the
grass deflector.
 Align the screw hole in the mounting bracket with the
screw hole in the grass deflector.
 Insert the wing screw through the mounting bracket and
into the grass deflector.
 Tighten the screw securely.
ASSEMBLY
HOLE
SEcOnDARy
HOLE
buTTOn
bOLT
GRASS
DEfLEcTOR
9 — English
fROnT HAnDLE
wASHER
TAb
SLOT
HAnGER
cAp
Fig. 3
wInG
nuT
Fig. 4
wInG
ScREw
Fig. 5