Jeep Wrangler Owner's Manual page 84

82 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
description under "Seat Belts In Passenger Seating Posi-
tions" section. The chart below defines the seating posi-
tions with an Automatic Locking Retractor (ALR) or a
cinching latch plate.
Driver
CRS Lock
First Row N/A
Second Row ALR
• N/A — Not Applicable
• ALR — Automatic Locking Retractor
Center Passenger
CRS Lock CRS Lock
N/A ALR
ALR ALR
Installing a Child Restraint with an ALR:
1. To install a child restraint with ALR, first, pull enough
of the seat belt webbing from the retractor to route it
through the belt path of the child restraint. Slide the latch
plate into the buckle until you hear a "click." Next,
extract all the seat belt webbing out of the retractor and
then allow the belt to retract into the retractor. As the belt
retracts, you will hear a ratcheting sound. This indicates
the safety belt is now in the Automatic Locking mode.
2. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt system
will loosen with time, so check the belt occasionally, and
pull it tight if necessary.