Virtual Wall ® Halo - iRobot Roomba Owner's Manual

Virtual Wall
(optional accessory for all models)
The Virtual Wall Halo is perfect for homes with pets. It sets up a protective
zone, gently guiding Roomba around your pet's food and water bowls to
keep the contents intact.
To set up the Halo, take the Virtual Wall out of the sleeve. Install batteries
as shown on the previous page. Set the Virtual Wall to "Auto" mode and
fully insert it into the sleeve. Make sure the Virtual Wall is inserted all the
way into the sleeve. The circular lens should be completely visible at the
top. Place the Virtual Wall Halo on the floor, level with Roomba, and in
close proximity to the bowls as shown below. If you have one bowl, put
it beside the Halo, almost touching the wall. For two bowls, place one on
either side.
bowl
x
bowl
TIP: Virtual Wall Halo works on non-metal bowls less than 10 inches (25 cm) in
diameter and up to 3.5 inches (9 cm) tall.
TIP: As Halo's battery levels get low, the field may not be strong enough to
protect your bowls. If that happens, change the batteries in the Virtual
Wall Halo.
Halo
®
protective zone
bowl
Halo
protective zone
Halo
For more detailed information, visit: www.irobot.com
protective zone
Halo
bowl
bowl
Protective zone
approximately 20
inches (50 cm) in
diameter
bowl
13