Advertisement
Docking & Charging other devices
An adhesive cover is included with the unit to support devices that do not
require the SmartSlide™ micro USB cable. To use, peel off the adhesive
backing and place the cover over the SmartSlide™. To charge the device,
connect it to the USB port on the left of the unit. Observe the charging
status of the device, and if needed, move the USB Circuit Switch located
on the bottom of the unit to the other position (A or B).
P L A Y I N G
M U S I C
LINE-IN JACK
Connect one end of the included stereo 3.5mm audio cable into the line-in
jack on the right of the unit and the other into the headphone or output
jack of your audio device. Turn the audio device on and put it in play
mode. Press the Power Button on the unit to turn it on. Adjust volume on
your audio device as needed. When you are through listening, make sure
to turn the unit off by pressing the Power Button. Remember to turn off
your audio device, too.
6
Advertisement
