How To Use Your Tractor - Husqvarna LTH1842 Owner's Manual

Hide thumbs Also See for LTH1842:
Table of Contents

Advertisement

The operation of any tractor can result in foreign objects thrown into the eyes, which can result
in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or
per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles
or stan dard safety glasses.
00155

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE (See Fig. 5)
Your tractor is equipped with an operator presence sens-
ing switch. When engine is running, any attempt by the
op er a tor to leave the seat without fi rst setting the parking
brake will shut off the engine.
Depress brake pedal into full "BRAKE" position and
hold.
Place parking brake lever in "ENGAGED" position
and re lease pressure from brake pedal. Pedal should
re main in "BRAKE" position. Make sure parking brake
will hold tractor secure.
IGNITION
THROT TLE /CHOKE
KEY
CONTROL
"BRAKE"
PO SI TION
02812
"DISENGAGED"
BRAKE PEDAL
POSITION
"DRIVE" POSITION
STOPPING (See Fig. 5)
MOWER BLADES -
To stop mower blades,move attachment clutch switch
to "DIS EN GAGED" po si tion.
GROUND DRIVE -
To stop ground drive, depress brake pedal into full
"BRAKE" position.
IMPORTANT: FORWARD AND REVERSE DRIVE PEDALS
RETURN TO NEUTRAL POSITION WHEN NOT DEPRESSED.
ENGINE -
Move throttle control between half and full speed (fast)
position.
NOTE: Failure to move throttle control between half and
full speed (fast) position, before stop ping may cause engine
to "backfi re".
Turn ignition key to "
Always remove key when leaving tractor to prevent
un author ized use.
Never use choke to stop engine.
IMPORTANT:
LEAVING THE IGNITION SWITCH IN ANY
POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY
TO BE DIS CHARGED, (DEAD).
NOTE: Under certain conditions when tractor is standing
idle with the engine running, hot en gine exhaust gases may
cause "browning" of grass. To eliminate this possibility, al-
ways stop engine when stopping tractor on grass areas.
OPERATION
ATTACHMENT CLUTCH
LEVER PULL OUT TO
"ENGAGE"
PUSH IN TO
"DISENGAGE"
REVERSE
PEDAL
FORWARD
PEDAL
CRUISE
CONTROL
LEVER
PARK ING BRAKE
"EN GAGED" POSITION
FIG. 5
" position and remove key.
STOP
CAUTION: Always stop tractor com-
plete ly, as described above, before leav-
ing the operator's position; to empty
grass catcher, etc.
TO USE THROTTLE CONTROL (See Fig. 5)
Always operate engine at full throttle.
Operating engine at less than full throttle reduces the
battery charging rate.
Full throttle of fers the best bagging and mower per for -
mance.
TO MOVE FORWARD AND BACKWARD
(See Fig. 5)
The direction and speed of movement is controlled by the
forward and reverse drive pedals.
Start tractor and release parking brake.
Slowly depress forward or reverse drive pedal to begin
movement. Ground speed increases the further down
the pedal is depressed.
TO USE CRUISE CONTROL
The cruise control feature can be used for forward travel
only.
SYSTEM CHARACTERISTICS
The cruise control should only be used while mowing or
transporting on relatively smooth, straight surfaces. Other
conditions such as trimming at slow speeds may cause the
cruise control to disengage. Do not use the cruise control
on slopes, rough terrain or while trimming or turning.
With forward drive pedal depressed to desired speed,
move cruise control lever forward to "SET" position and
hold while lifting your foot off the pedal, then release
the cruise control lever.
To disengage the cruise control, pull the lever backward
to "OFF" position, or fully depress the brake pedal.
TO ADJUST MOWER CUTTING HEIGHT (See
Fig. 4)
The position of the attachment lift lever determines the
cutting height.
Grasp lift lever.
Press plunger with thumb and move lever to desired
position.
The cutting height range is approximately 1-1/2 to 4".
The heights are measured from the ground to the blade tip
with the engine not running. These heights are approximate
and may vary depending upon soil conditions, height of
grass and types of grass being mowed.
The average lawn should be cut to approximately 2-1/2
inches during the cool season and to over 3 inches
during hot months. For healthier and better looking
lawns, mow often and after moderate growth.
For best cutting performance, grass over 6 inches
in height should be mowed twice. Make the fi rst cut
relatively high; the second to desired height.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents